133 E. Jericho Turnpike
Mineola, NY 11501

516-248-1850

Project Metamorphosis:
A Sportster for the New Millenium

Part 2: The final test assembly

Roland requested that we finish his scooter as soon as we could. This project was gonna be a quick one from the start, so we’ve got a second installment just a bit over a month after beginning the project. We’re rollin’!
Picture

At left is the bike sitting in our showroom, complete except for the fuel tank.

Soon after these shots were taken, the bike was stripped and sent out for powder coating and painting. The powder color used on the frame, lower fork legs, and other miscellaneous parts is a retina-searing yellow.  The sheetmetal will be yellow with wild graphics.

The bike got a D&D “Fat Katz” 3-inch stretched, one-piece tank, as shown at right.

Below is the final mock-up of the bike complete with tank and Porker shotgun exhaust system.
Picture
Picture
Picture

On to Part 3

Back to Cycle Creations main page

Here’s another shot from the rear. Way wide rubber, no?

All the parts should be back in about one month, and we’ll be starting final assembly, so don’t go far!

Original web page development by

LP_Design_12pt.GI Picture

© 1998-Present by D. G. Lambert. All rights reserved.
No portion of this work, including photographs, may be reproduced in whole or in part without the prior consent of the copyright owner.  All brand or product names are trademarks or registered trademarks of their respective companies or organizations.